Service and Safety ... 2 Safe Operation Rules ...
LEHR | ALL RIGHTS RESERVED 2008-200910STARTING/STOPPINGSTARTING INSTRUCTIONS1. Check the oil level in the crankcase. Refer to Checkingthe Oil Level (
LEHR | ALL RIGHTS RESERVED 2008-200911OPERATING YOUR TRIMMERBefore operating the unit, stand in the operating posi -tion (Fig. 15). Check for the foll
LEHR | ALL RIGHTS RESERVED 2008-200912WARNING:FREQUENCY MAINTENANCE REQUIRED REFER TOBEFORE STARTING ENGINE CHECK OILPAGE 6EVERY 10 HOURS CLEAN AND
LEHR | ALL RIGHTS RESERVED 2008-200913Fig. 204-Cycle Motor OilCHANGING THE OILFor a new engine, change the oil after the rst 10 hours of operation. C
LEHR | ALL RIGHTS RESERVED 2008-200914CARURETOR ADJUSTMENTThe idle speed of the engine is adjustable. An idle adjust -ment screw is on the rear side o
LEHR | ALL RIGHT RESERVED 2008-200915Fig.24Bump Feed ButtonHoleTRIMMER HEAD LINE INSTALLATIONSMALL BUMP FEED HEAD (.080” Line)1. Review gure 28 for n
LEHR | ALL RIGHTS RESERVED 2008-200916Fig.34Snap to groove to pull through coverTRIMMER HEAD LINE INSTALLATIONLARGE BUMP FEED HEAD (.095” Line)1. Lock
LEHR | ALL RIghTS ReSeRved 2008-200917BrUSH CUTTer BlaDe remoVal / inSTallaTion1.Remove the cotter pin (Fig. 38).Fig. 38Left-Hand Thread NutCotter Pin
LEHR | ALL RIGHTS RESERVED 2008-200918Fig.43Rocker Arm CoverRocker Arm Cover Screws8. Pull the starter rope slowly to bring the piston to the top of i
LEHR | ALL RIGHTS RESERVED 2008-200919CLEANING AND STORAGECLEANINGUse a small brush to clean the outside of the unit. Do not use strong detergents. Ho
LEHR | 2LEHR ECO-TRIMMER4-CYCLE PROPANE TRIMMERFor service call 1-866-941-LEHR in the United States, to obtain a list of authorized service dealers
LEHR | ALL RIGHTS RESERVES 2008-200920ENGINE*ENGINE TYPEAIR COOLED 4-CYCLEDISPLACEMENT25.4 CCCLUTCH TYPE CENTRIFUGALOPERATING R.P.M.6,800-9300 R.P.M.I
LEHR | ALL RIGHTS RESERVED 2008-200921The limited warranty set forth below is given by LEHR with respect to new merchan-dise purchased and used in the
LEHR | ALL RIGHT RESERVED 2008-200922NOTES
LEHR | ALL RIGHTS RESERVED 2008-20093outside a 50 feet (15 m.) radius; there still may be a risk • Use only original equipment manufacturer replacemen
LEHR | ALL RIGHTS RESERVED 2008-2009 4This operator’s manual describes safety and international symbols and pictographs that may appear on this pr
LEHR | ALL RIGHTS RESERVED 2008-20095 WARNING:INSTALLING CUTTING ATTACHMENT SHIELDUse the following instructions if the cutting attachment shield on y
LEHR | 6OIL INFORMATIONRECOMMENDED OIL TYPEUsing the proper type and weight of oil in the crankcase is extremely important. Check the oil before each
LEHR | ALL RIGHTS RESERVED 2008-20097SAFETY WARNINGS FOR PROPANE UNITSNOTE: Use propane only in containers specically designed and approved for this
LEHR | 8USE THE CORRECT PROPANE CANISTERAlways use Propane canisters or “Bottles” that are the correct size. The 17 ounce or 16.4 ounce/465 g can -ist
LEHR | ALL RIGHTS RESERVED 2008-20099Fig. 1190° EdgingHoleINSTALLING CUTTING ATTACHMENTS OR ADD-ONSNOTE: Place the unit on the ground or on a work ben
Comments to this Manuals